beautypg.com

Nor-Lake General Purpose Lab Ref-Fzr User Manual

Page 7

background image

7

05/07 138708

TRIM REMOVAL (Full Length Trim Models Only)

In some models, the refrigerator door has a full length trim piece which continues from the bottom of

the handle to the bottom of the door. The top of the trim attaches to the handle bracket (see Figure

1) or fits around the base of the handle (see Figure 2). An adhesive trim lock is positioned

approximately half way down the trim piece. The bottom of the trim is secured by either an adhesive

trim lock or a trim lock with two prongs inserted into a hole on the face of the door.
REMOVE TRIM:

1. Remove the trim by gently pulling the trim lock areas out and away from the door.

2. When the trim is free from the door, slide the trim straight down and away from the base of

the handle. Note: For models with a short handle trim, remove by sliding the trim straight

down and off the handle bracket.



REMOVE/REVERSE REFRIGERATOR HANDLE

(Handles may be easier to reverse while doors are off.)


Figure 1 Style Handles

1. Remove the two screws attaching the handle to the top of the refrigerator door.

2. Remove the screw attaching the bottom of the handle to the door.

3. Remove the two hole plugs and hinge pin plug on the top of the door and reinstall them on

the opposite side of the door. Use a Phillips head screwdriver to remove the plastic screw

plug from the front of the door and reinstall it on the opposite side of the door.


Figure 2 Style Handles

1. Remove the two screws attaching the handle to the top of the refrigerator door.

2. Swing the top of the handle away from the door and slide the handle down and off the

dovetail button.

3. Remove the screw and dovetail button and reinstall them on the opposite side of the door

and move the hole plugs from the corresponding holes to the opposite side.


REATTACH REFRIGERATOR HANDLE


Figure 1 Style Handles

1. Secure the bottom of the handle with the screws removed above.

2. Secure the top of the handle with the screws removed above.


Figure 2 Style Handles

1. Start with the handle offset away from the door. Place the bottom of the handle over the

dovetail button, swing the handle into an upright position and pull upward locking the handle

into place.

2. Secure the top of the handle with the screws removed above.


TRIM ATTACHMENT

1. Slide both trim locks out of the trim.

2. Insert new adhesive trim locks contained in the literature pack.

3. Install the trim to the handle by sliding under the base of the handle. Carefully align the trim

and press down at the trim lock locations.

4. Use rubbing alcohol to remove any adhesive residue from the old trim lock locations.