Nor-Lake AdvantEDGE Chef Base - Manual (Page 3)

08/13 Rev. E 147774 3
TROUBLESHOOTING
Problem Remedy
Compressor will
not start
· Check the power cord and make sure it is plugged in.
· Check the temperature controller. If it is in the “OFF” position,
turn it clockwise to set a desired temperature.
Poor
performance
· Move the unit from direct sunlight.
· Move the unit away from heating devices.
· Install the unit in a well ventilated place, with at least 7 inches of
clearance on all sides.
· Clean the condenser if heavy dust is collected.
· Clear contents from blocking the air duct.
· Check the temperature controller for incorrect setting.
· Check the refrigerant level, it may need to be charged.
· Check the door and be sure it is completely closed.
Unit noisy
· Install the unit on a level surface.
· Maintain 7 inches of clearance from the wall.
· Check for loose part or mounting.
· Keep the tubing free from any contact to avoid rattle.
Condensation on
cabinet exterior
and/or floor · Reduce humidity where the unit is installed.
· Repair or replace the gasket on the door.