Nor-Lake Angled Ice Cream Merchandisers - Manual (Page 3)

3
INTRODUCTION
This manual contains important instructions for installing, using, and servicing your Novelty Display case. A parts list
is included with this manual. Read all these documents carefully before installing or servicing your equipment.
STORE CONDITIONS
The case are designed to operate in the controlled environment of an air-conditioned store. The store temperature
should be at or below 75
°F and a relative humidity of 55% or less. At higher temperature or humidity conditions, the
performance of these cases may be affected and the capacity diminished.
The Novelty Display case should not be positioned where it is directly exposed to rays of sun or near a direct source
of radiant heat. This will adversely affect the case and will result in poor performance.
NOTICE
Read this manual before installing your cabinet. Keep the manual and refer to it before doing any service on
the equipment. Failure to do so could result in personal injury or damage to the cabinet.
DANGER
Improper or faulty hook-up of electrical components on the refrigeration units can result in severe injury or
death.
All electrical wiring hook-ups must be done in accordance with all applicable local, regional or national
standards.
NOTICE
Installation and service of the refrigeration and electrical components of the case must be performed by a
refrigeration mechanic and/or a licensed electrician.
The portions of this manual covering refrigeration and electrical components contain technical instructions intended
only for persons qualified to perform refrigeration and electrical work. This manual cannot cover every installation, use
or service situation. If you need additional information, call or write our Customer service department.