Airlink101 APO1200 - Manual (Page 4)

3
2. Hardware Installation
1. Connect N-type antenna to the N-type connector on
the rear panel
3. Connect the opposite end of the RJ-45 cable to the
P+DATA OUT port on the Power over Ethernet
Injector
4. Connect one end of another RJ-45 cable to
the DATA IN port on the Power over
Ethernet Injector
2. Connect one end of a RJ-45 cable into the
AP's PoE connector
5. Connect the opposite end of the RJ-45 cable to a
LAN port on your network or Computer
6. Connect the power cord into the Power over
Ethernet Injector. Then connect the power
cord to a power outlet.