Alamo SHD88 - Manual (Page 83)

ASSEMBLY
SHD 03/09 Assembly Section 3-5
© 2009 Alamo Group Inc.
ASSEMBL
Y
DRIVELINE ATTACHMENT
Before starting assembly, make certain that all
paint, dirt, and grease are removed from gearbox
shaft (1). To ease assembly apply a light coat of
grease to splines and assemble. Do not assemble a
drive line without a shield.
Attach the slip clutch end of the driveline to the
gearbox input shaft securely. Make certain that the
slip clutch is fully onto the input shaft splines.
Tighten the locknuts (2) alternately until they have
reached the proper torque. See Image ASMP-FL-
0017.
Refer to Torque Chart in the Maintenance Section
RUBBER DEFLECTOR ATTACHMENT
Attach rubber deflector to mower using 1/4” x 7/8”
bolts, washers, and locknuts with bolthead located
on the underside of deflector as shown in Image
ASMP-FL-0018.