Alamo SHD88 - Manual (Page 110)

OPERATION
SHD 03/09 Operation Section 4-24
© 2009 Alamo Group Inc.
OPERA
T
ION
10.3 Raising the Mower
Using the tractor 3-point hitch control lever, raise
the mower off the ground about 6”, or just high
enough to clear any ground obstacles. When
raising the mower, make sure all connection points
are securely attached and at least 1” clearance is
maintained between the driveline and the deck. If
necessary, place an upper lift strip on the 3-point
hitch control lever to limit the height the mower can
be raised to avoid driveline damage.
10.4 Driving the Tractor and Mower
Start off driving at a slow speed and gradually increase your speed while maintaining control of the tractor and
mower. Moving slowly at first will also prevent the tractor from rearing up and loss of steering control. The
tractor should never be operated at speeds that cannot be safely handled or which will prevent the operator
from stopping quickly during an emergency. If the power steering or engine ceases operating, stop the tractor
immediately as the tractor will be difficult to control.
Drive the tractor with the 3-Point lift arms in the raised position and lock the control lever in the transport detent
position to prevent damage to the mower driveline and tongue when turning.
Perform turns with the tractor and mower at slow
speeds to determine how the tractor with an
attached mower handles a turn. Determine the safe
speed to maintain proper control of the tractor when
making turns. When turning with a towed
implement, the overall working length of the unit is
increased. Allow additional clearance for the mower
when turning.
To avoid overturns, drive the tractor with care and at
safe speeds, especially when operating over rough
ground, crossing ditches or slopes, and turning
corners. Tractor wheel tread spacing should be
increased when working on inclines or rough
ground to reduce the possibility of tipping.
Use extreme caution when operating on steep
slopes. Keep the tractor in a low gear when going
downhill. DO NOT coast or free-wheel downhill.
OPS-F- 0018