Autostart AS-6450VTW-FM - Manual (Page 15)

User Guide P. 15
Home Valet
If this feature is enabled, the user has the option of setting the vehicle to a no-remote-start mode.
The alarm functions will still be active.
Turbo Mode
When left in turbo mode, the remote starter will keep the engine running for 60 seconds before
shutting it down. This is to allow a turbocharger to idle down after the user leaves the vehicle.
Engine Run Time
If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
Extended Run Time
While the vehicle is running under a remote start, pressing and holding the START/STOP button
for more than 3 seconds will reset the run time counter to zero and restart the run time cycle from
the beginning. There will be one beep
a pause three more beeps; the parking lights will flash
three times. The extended run time procedure can only be carried out once per remote start.
To stop the vehicle, at any moment, simply press the
START/STOP button.
Example: If your remote car starter is programmed for a run time of 4 minutes and your vehicle
has been running for 3 minutes already, pressing the START/STOP button will reset the
counter to zero and allow the engine to run for another cycle (in this case, 4 minutes).
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same remote starter model, to
control both systems with a single remote control. To control the second vehicle:
Press TRUNK + LOCK buttons simultaneously:......................... LOCK
Press TRUNK + UNLOCK simultaneously:................................. UNLOCK
Press TRUNK + START/STOP simultaneously :...................................START
Press TRUNK + START/STOP simultaneously : ........................... STOP
Press SHIFT ¾ SHIFT ¾ TRUNK: ................................................ TRUNK
or
Press SHIFT ¾ SHIFT ¾ LOCK :.................................................. LOCK
Press SHIFT ¾ SHIFT ¾ UNLOCK :............................................. UNLOCK
Press SHIFT ¾ SHIFT ¾ START/STOP: ..................................................START
Press SHIFT ¾ SHIFT ¾ START/STOP: ........................................ STOP
Press SHIFT ¾ SHIFT ¾ TRUNK: ................................................ TRUNK
Note: In order to access the 2 nd car operations with the companion remote, the SHIFT button must
be pressed twice quickly and then one more time followed by LOCK, UNLOCK, TRUNK or START / STOP
(depending on what you want to do).
Note: If the multi-level features have been modified from their default state by your installer,
the
SHIFT button may have to be pressed once, twice or three times, according to the option
you chose.
Shock Sense, Warn-away Sense
(Both enabled by default.) Your System will react to a full shock by triggering the alarm; it can also
respond to a lighter shock (30 % of the strength of a full shock) by giving a warning (without
triggering an alarm condition).
Note: During a remote start, the shock sensor is disabled. However, all the other alarm-
triggering zones (such as the doors, the trunk or the hood) will still trigger the alarm.