Asus M2N-L - Manual (Page 70)

-20 Chapter : BIOS setup
4.4.3 Onboard Devices Configuration
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Configuration options: [Disabled] [3F8/IRQ4] [3E8/IRQ4]
Serial Port2 Address [2F8/IRQ3]
Allows you to select the Serial Port2 base address.
Configuration options: [Disabled] [2F8/IRQ3] [2E8/IRQ3]
Serial Port2 Mode [Normal]
Allows you to set the BIOS selection mode for Serial Port2.Configuration
options: [Normal] [IrDA] [ASK IR]
The following items appear when the Serial Port2 Mode is set to IrDA or ASK IR.
CMOS Port Dulpex Mode [Half Duplex]
Allows you to select full or half duplex for Serial Port2 (IR Mode).
Configuration options: [Half Duplex] [Full Duplex]
Onboard XGI Z9S VGA [Enabled]
Enable or disable the Onboard XGI Z9S VGA.
Configuration options: [Disabled] [Enabled]
Configure ITE8716F-S Super IO Chipset
Serial Port1 Address [3F8/IRQ4]
Serial Port2 Address [2F8/IRQ3]
Serial Port2 Mode [Normal]
Configure Onboard Device
Onboard XGI Z9S VGA [Enabled]
Onboard MARVELL8056 Lan A [Enabled]
Onboard Lan BootROM [Disabled]
Onboard MARVELL8056 Lan B [Enabled]
Onboard Lan BootROM [Disabled]
Allows BIOS to Select
Serial Port1 Base
Addresses.