Panasonic TYWK6P1RW - Manual (Page 8)

8
English
6. Mounting the plasma TV onto the wall-
hanging bracket and connecting it to
the other components
Cutout at top
Insulation spacer at bottom



Hole at bottom
Surface of wall Surface of wall
Notes
• Connect the cables and cords of the connecting components
before mounting the plasma TV to the wall-hanging bracket.
• When mounting the plasma TV to the wall-hanging bracket, make
sure that cables and cords do not get pinched between the plasma
TV and the wall-hanging bracket.
• Refer to the plasma TV instruction manual for connecting the
plasma TV to the other components.
 Fit the insulation spacers at the top of the plasma TV onto
the cutout at the top of the wall-hanging bracket.
 Slowly lowering the plasma TV, insert the insulation spacers
at the bottom into the holes at the lower part of the wall-
hanging bracket.
 Now lower the plasma TV.
CAUTION
• If the plasma TV is lifted too much, its top part will become
disengaged from the wall-hanging bracket.
Hole for mounting the screw
for securing unit
M5 × 50 Screw for securing unit 
Wall-hanging bracket
Surface of wall
7. Anchoring the plasma TV
Install the accessory screws for securing unit  (2) into
the mounting holes of the screws for securing unit on the
sides (left and right) of the wall-hanging bracket.
Note
• In order to prevent the plasma TV from becoming disengaged
from the wall-hanging bracket, the screws for securing unit 
must be securely tightened at the left and right as far as their
bases.
Connecting additional components
 Remove the left and right red-marked screws  (one at the
left and one at the right) used to anchor and release the
plasma TV.
 Lifting the plasma TV slightly and pulling it forward, pull out
the insulation spacers at the bottom.
 Pull the plasma TV forward, and connect the connecting
components’ cables or cords to the terminals on the back.
 Lifting the plasma TV slightly, insert the bottom insulation
spacers into the holes at the lower part of the wall-hanging
bracket.
 Now lower the plasma TV.
 Securely tighten the left and right red-marked screws  (one
at the left and one at the right) used to anchor and release
the plasma TV in the red-marked screw mounting holes on
the side of the wall-hanging bracket.
(Tightening torque: 1.2 to 1.5 N•m)
 Red-marked screw 
used to anchor and
release the plasma TV
Hole at
bottom Insulation spacer at
the bottom



 Red-marked screw 
used to anchor and
release the plasma TV

Surface of wall Surface of wall
Note
• When connecting components to the plasma TV, ask a qualified
installation specialist.
Fitting procedure