beautypg.com

Connecting to a 3d sync transmitter – Sony VPL-VW95ES User Manual

Page 28

background image

28

The projector incorporates a 3D Sync Transmitter. Depending on the installation
environment of the projector, the 3D glasses may not received 3D signals properly from
the projector’s built-in 3D Sync Transmitter. In this case, connect an optional 3D Sync
Transmitter and place it near your viewing position.

Tip
Place the optional 3D Sync Transmitter directly facing the 3D glasses. Also, in order to stabilize
operation of the 3D glasses, it is recommended that you place the 3D Sync Transmitter near your
viewing position.

CAUTION
Be sure to use straight-type LAN cable of up to 15 m labeled TYPE CM, and do not use
an extension cord.

• The 3D SYNC connector is dedicated for the optional 3D Sync Transmitter. Do not connect

computers or other network devices, to avoid malfunction.

• You can use a 3D Sync Transmitter separate from this unit, using an optional LAN cable (straight-

type).
If the usage environment has interference of a continuous specific frequency, synchronization of
3D image signals and the 3D glasses may be lost. In this case, use a LAN cable labeled Category 7.
When watching 3D images in an environment that has even more interference, use the internal
transmitter.

• Be sure to use cable of up to 15 m, and do not use an extension cord. Also, keep the LAN cable

away from any AC power cords as much as possible.

• Only one 3D Sync Transmitter should be connected to the unit. Connecting multiple 3D Sync

Transmitters may cause a malfunction.

• When connected to the 3D Sync Transmitter, the built-in 3D Sync Transmitter feature of the unit

will turn off. You cannot use both at the same time.

Connecting to a 3D Sync Transmitter

Notes

Right side of the projector

3D Sync Transmitter (not supplied)

LAN cable

: 3D sync signal flow