Sony MXD-D40 - Manual (Page 17)

Playing CDs and MDs
17
2
Turn AMS until the desired track appears.
3
Press AMS.
The track is programed. The number of the last
programed track appears, followed by the total
playing time of the program.
4
To program additional tracks, repeat steps 2 and
3.
5
Press · to start Program Play.
To stop Program Play
Press p.
To cancel Program Play
While the deck is stopped, press PLAY MODE
repeatedly until “PROGRAM” disappears.
To select the desired track using the number
buttons
Press number buttons instead of performing steps 2
and 3.
To enter track numbers 10 or over, press >10 and the
track number. To enter 0, use the 10/0 button.
To erase the last programed track
Press CLEAR. Each time you press the button, the last
programed track is erased.
z
The program remains even after Program Play ends
When you press ·, you can play the same program
again.
Notes
• The display shows “- - . - -” instead of the total playing
time when the total playing time of the program exceeds
99 minutes (999 minutes for MD).
• “Step Full!” appears when you program over 25 tracks.
Erase the unnecessary tracks to enter other tracks.
• The program is erased when you disconnect the AC power
cord.
• You cannot use D.SKIP on the remote.
Falling Asleep to Music (Sleep
Timer)
You can let the deck turn off after the specified time, so
you can sleep to the music.
You can specify the time until the deck turns off by 30
minutes.
1 / u
SLEEP
Press SLEEP.
Each time you press the button, the minute display (the
turn-off time) changes as follows, and then returns to
the original display after a short time. When the Sleep
Timer is activated, “SLEEP” appears in the display and
the deck turns off after the displayed time has passed.
n Off (Sleep Timer canceled) n 30min
120min N 90min N 60min N
To check the remaining time
Press SLEEP once.
To change the time to turn off
Press SLEEP repeatedly to select the desired time.
To cancel the Sleep Timer operation
Press SLEEP repeatedly until “Off” appears.