The install setting menu – Sony VPL-BW120S User Manual
Page 29
29
The INSTALL SETTING Menu
A
d
ju
s
tm
e
nt
s an
d Set
tin
g
s
U
s
in
g a M
enu
The INSTALL SETTING Menu
The INSTALL SETTING menu is used for installing the projector.
*1: Since the Keystone adjustment is an electronic correction, the image may be deteriorated.
*2: When “High Altitude Mode” is set to “On,” the speed of the fan increases, and the fan noise
becomes slightly louder.
*3: You will not be able to use the projector if you forget your password. If you call qualified Sony
personnel because you have forgotten the password, you will be asked to verify the projector’s
serial number and your identity. (This process may differ in other countries/regions.) Once your
identity has been confirmed, we will provide you with the password.
Items
Item descriptions
V Keystone
*1
Auto: Set keystone adjustment automatically. When the projector is
installed on an uneven surface, the feature may not work properly. In this
case, select “Manual” to set keystone adjustment manually.
Manual: The higher the setting, narrower the top of the projected image.
The lower the setting, narrower the bottom of the projected image.
Image Flip
HV/H/V/Off: Flips the projected image horizontally and/or vertically
according to the installation method.
Background
Black/Blue: Selects the background color of the projected image when no
signal is input.
Lamp Mode
High/Low: When set to “High,” the image becomes brighter, and power
consumption becomes higher.
High Altitude
Mode
*2
On/Off: Set to “On” when using the projector at an altitude of 1,500 m or
higher. Continuing to use the wrong setting may affect component
reliability.
Security Lock
*3
On/Off: This function enables restriction of the projector to authorized
users by password. The setting procedures for security locking are as
follows:
1 Select “On” and press ENTER to display the setting menu.
2 Input the password with the MENU,
V/v/B/b, and ENTER keys. (The
default password setting is “ENTER, ENTER, ENTER, ENTER.”)
3 Input a new password with the MENU,
V/v/B/b, and ENTER keys.
4 Enter the password again to confirm.
Enter the password when you turn on the projector after disconnecting and
reconnecting the AC power cord.
When it is set to “Off,” you can cancel the security lock. You are required to
input the password again.
If you fail to enter the correct password after three consecutive times, the
projector cannot be used. In this case, press the ?/1 key to go Standby
mode then turn on the power again.
Direct Power On
On/Off: When set to “On,” you can turn the power on without going to
Standby mode when the AC power cord is connected to a wall outlet.
Regardless of the Direct Power On setting, you can disconnect the AC
power cord to turn off the power without going to the Standby mode.
Standby Mode
Standard/Low: When set to “Low,” lowers power consumption in Standby
mode.
Notes