Sony MZ-NF810 - Manual (Page 97)

97
Connecting the Net MD to your computer
After the software installation is completed, connect the Net MD to your computer.
Refer to the operating instructions of the Net MD as well.
1
Insert a recordable disc into the Net MD.
2
Make the power source and the dedicated USB cable connections with the Net
MD and the computer.
3
Check the connections.
When the connections have been properly
made, “PC
ppMD”* appears in the display of
the Net MD.
*Depending on the device, “Net MD” may be
displayed.
Notes
• When using the Net MD connected to your computer, it is recommended that you run the recorder
from an AC outlet. If you use a battery to run the Net MD, be sure to use a new dry cell or a fully
charged rechargeable battery. We do not assure the results should there be a mis-operation, check-out
failure, or destruction of audio data caused by insufficient battery power.
• When using the Net MD with the cradle, place the cradle on a stable surface so that the dedicated USB
cable does not become detached.
Net MD
devices*
Dedicated
USB cable
To the USB
connecting
terminal To the USB jack/
dedicated jack
Computer
AC
power
adaptor
To the DC IN
jack
* If a cradle is supplied with your Net MD, connect the dedicated USB cable to the
USB cradle and place the Net MD onto the USB cradle.