Sony MDS-JE440 - Manual (Page 53)

53
masterpage:Right filename[\\Win-35\logitecmo\422958711MDSJE640CED\01GB03OPE-CED.fm]
Self-diagnosis function
Ad
d
itiona
l In
fo
rmati
o
n
model name1[MDS-JE640] model name2[MDS-JE440]
[4-229-587-11(1)]
Self-diagnosis function
The deck’s self-diagnosis function automatically checks
the condition of the MD deck when an error occurs, then
issues a three- or five-digit code and an error message on
the display. If the code and message alternate, find them in
the following table and perform the indicated
countermeasure. Should the problem persist, consult your
nearest Sony dealer.
Three- or five-
digit code/
Message
Cause/Remedy
C11/Protected
The inserted MD is record-protected.
, Take out the MD and close the record-
protect slot (page 14).
C12/Cannot Copy
You tried to record a CD with a format
that the external device connected to the
deck does not support, such as CD-ROM
or video CD.
, Remove the disc and insert a music
CD.
C13/REC Error
The recording was not made properly.
, Set the deck in a stable surface, and
repeat the recording procedure.
The inserted MD is dirty (with smudges,
fingerprints, etc.), scratched, or
substandard in quality.
, Replace the disc and repeat the
recording procedure.
C13/Read Error
The deck could not read the TOC on the
MD properly.
, Take out the MD and insert it again.
C14/Toc Error
The deck could not read the TOC on the
MD properly.
, Insert another disc.
, If possible, erase all the tracks on the
MD (page 32).
C41/Cannot Copy
The sound source is a copy of
commercially available music software, or
you tried to record a CD-R (Recordable
CD).
, The Serial Copy Management System
prevents making a digital copy
(page 52). You cannot record a CD-R.
C71/Din Unlock
The sporadic appearance of this message
is caused by the digital signal being
recorded. This will not affect the
recording.
While recording from a digital component
connected through the DIGITAL IN
connector, the digital connecting cable
was unplugged or the digital component
turned off.
, Connect the cable or turn the digital
component back on.
E0001/
MEMORY NG
There is an error in the internal data that
the deck needs in order to operate.
, Consult your nearest Sony dealer.
E0101/
LASER NG
There is a problem with the optical
pickup.
, The optical pickup may have failed.
Consult your nearest Sony dealer.
Three- or five-
digit code/
Message
Cause/Remedy