Sony MDS-JE440 - Manual (Page 28)

28
masterpage:Left filename[\\Win-35\logitecmo\422958711MDSJE640CED\01GB03OPE-CED.fm]
Creating your own program
Pla
y
ing
M
D
s
model name1[MDS-JE640] model name2[MDS-JE440]
[4-229-587-11(1)]
4 Repeat step 3 to enter other tracks.
The entered track is added to the location where the
“0” flashes.
Each time you enter a track, the total program time
appears in the display.
5 Press YES.
“Complete!!” appears and the program is completed.
6 Press PLAY MODE repeatedly until “PGM” lights up
in the display.
7 Press H .
Program Play starts.
To stop Program Play
Press x.
To resume normal play
Press PLAY MODE repeatedly until “PGM” turns off.
z
The program remains even after Program Play ends or
is stopped
Press H to play the program again.
Notes
• If you eject the MD, the program will be lost.
• The display shows “- - - . - -” when the total playing time of
the program exceeds 999 minutes.
• “ProgramFull(!)” appears when you try to program the 26th
track.
While the deck is stopped and “PGM” lights up, press
LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly.
The first several tracks in the program appear in the
display. To see the rest of the program, turn AMS (or press
> repeatedly).
While the deck is stopped and “PGM” lights up, do steps
1 and 2 of “Programing the tracks” on page 27, followed
by one of the procedures below:
Checking the order of the program
Changing the contents of the program
To Do the following:
Erase a track
Press m/M repeatedly
until the number of the
unwanted track flashes, then
press CLEAR.
Erase all tracks
Press down CLEAR until all
the track numbers disappear.
Add a track at the beginning
of the program
Press m repeatedly until “0”
flashes before the first track
number, then do steps 3 to 5 of
“Programing the tracks” on
page 27.
Add a track in the middle of
the program
Press m/M repeatedly
until the track number which
will precede the new track
flashes. Press AMS to display
flashing “0,” then do steps 3 to
5 of “Programing the tracks”
on page 27.
Add a track to the end of the
program
Press M repeatedly until “0”
flashes after the last track
number, then do steps 3 to 5 of
“Programing the tracks” on
page 27.
Replace a track
Press m/M repeatedly
until the number of the track to
be changed flashes, then do
steps 3 to 5 of “Programing the
tracks” on page 27.
To Do the following: