Alpine CDE-W203RI - Manual (Page 28)

26
-EN
• Abnormal current is run to the USB connector device (an error
message may be displayed if the USB device that is not
compatible with the unit is connected).
USB memory is a malfunction or it is shorted.
- Connect another USB memory.
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
• A USB memory is not connected.
- Make sure the USB memory device is correctly connected and
the cable is not excessively bent.
• No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
• Text information that is not recognizable by the unit has been
input.
- Use a USB memory device with input text information that is
supported by the unit.
• The iPhone/iPod is not connected.
- Make sure the iPhone/iPod is correctly connected (refer to
“Connections”).
Make sure the cable is not bent excessively.
• There are no songs in the iPhone/iPod.
- Download songs to the iPhone/iPod and connect to this unit.
• Communication error.
- Turn the ignition key off, and then set to ON again.
- Check the display by reconnecting between the iPhone/iPod
and this unit, using the iPhone/iPod cable.
- Reset the iPod.
• Caused by the iPhone/iPod Software Version not being
compatible with this unit.
- Update the iPhone/iPod Software Version to be compatible
with this unit.
• The iPhone/iPod is not verified.
- Reset the iPod.
- Try another iPhone/iPod, if available.
• Power surge error.
Excessive voltage/current is supplied to the iPhone/ iPod.
- Try another iPhone/iPod, if available.
• The Bluetooth device is not connected.
- Connect the Bluetooth device.
• Malfunction occurred as a result of the speaker cable shorting on
the car chassis.
- Route the cable correctly, and set POWER IC to ON (page 19).
If the above solution does not work, consult your nearest
dealer.
Indication for USB memory
UNIT ERROR
NO DEVICE
NO SUPPORT
Indication for iPod Mode
Bluetooth mode
Indication for all Modes