Alpine CDE-W203RI - Manual (Page 10)

8
-EN
Setting the Dimmer Control
1
Press FUNC./SETUP so that the indicator
lights up.
2
Press 6/DIMMER repeatedly to select the DIMMER
mode.
DIMMER-A (Auto mode) DIMMER ON DIMMER OFF
DIMMER-A
DIMMER-A mode:
Decrease the illumination brightness of the unit with the head
lights of the vehicle ON. This mode is useful if you feel the unit’s
backlighting is too bright at night.
DIMMER ON mode:
Keep the illumination brightness of the unit dark.
DIMMER OFF mode:
Keep the illumination brightness of the unit bright.
3
Press FUNC./SETUP to activate the normal mode.
The indicator goes out.
• Operate the unit while the indicator lights up. If no operation is
performed for 10 seconds, the indicator goes out.
Listening to Radio
1
Press SOURCE/ to select TUNER mode.
2
Press BAND/TA repeatedly until the desired radio
band is displayed.
F1 (FM1) F2 (FM2) F3 (FM3) MW LW F1 (FM1)
3
Press TUNE/A.ME to select the tuning mode.
DX SEEK (Distance mode) SEEK (Local mode)
OFF (Manual mode) DX SEEK
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or will change the frequency
continuously.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote
control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote
control sensor.
Connectable to Remote Control Interface Box
This unit may be controlled from the vehicle’s audio controls.
An optional Alpine Remote Control Interface Box must be
used. For details, contact your Alpine dealer.
Remote control sensor
Radio
SOURCE/
BAND/TA
Preset buttons
(1 through 3)
FUNC./SETUP
Preset buttons
(4 through 6)
TUNE/A.ME