Alpine CDE-W203RI - Manual (Page 23)

21
-EN
USB memory Connection (Optional)
Connect USB memory
1
Open the cover of the USB Connection Terminal.
2
Connection the USB memory directly to the USB
Connection Terminal, or via the USB cable.
Remove USB memory
1
Carefully, pull out the USB memory from the USB
cable or the USB Connection Terminal.
2
Close the cover of the USB Connection Terminal.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognized even when
USB memory is connected, remove USB memory once, and then
connection it again.
• Route the USB cable away from another cables, etc.
• After removing the USB memory, close the cover of the USB
Connection Terminal to prevent dust or foreign objects from entering
and causing a malfunction.
About MP3/WMA/AAC File of USB
Memory
Playing back MP3/WMA/AAC
MP3/WMA/AAC files are prepared, then stored to a USB
memory. This unit can recognise at least 100 folders and
100 files per folder stored in USB memory. Playback may not be
performed if a USB memory exceeds the limitations described
above.
Do not make a file’s playback time more than 1 hour.
Media supported
This device can play back USB memory.
Corresponding File Systems
This device supports FAT 12/16/32 for USB memory device.
An iPhone/iPod can be connected to this unit by using the proprietary
ALPINE FULL SPEED
™ Connection Cable (supplied). When this unit
is connected by using the cable, the controls on the iPod are not
functional.
• Set AUX+ SETUP to OFF when an iPhone/iPod is connected (refer
to “Setting the AUX+ SETUP Mode” on page 20).
• If the Bluetooth INTERFACE (KCE-400BT) and an iPhone/iPod are
connected at the same time, be sure to disconnect the iPhone/iPod
from Bluetooth INTERFACE (KCE-400BT) while turning ACC to
OFF.
• Internet and telephone functions of iPod touch or iPhone, etc., can
also be used when connecting to the unit. However, using these
functions will stop or pause the playing songs, at this time do not
operate the unit to avoid a malfunction.
• If you connect an iPhone to this unit, it can be used as an iPod. If you
use iPhone as a hands-free phone, you need the optional Bluetooth
INTERFACE (KCE-400BT).
• Do not leave an iPhone/iPod in a car, as its mechanism is sensitive to
high temperature and humidity conditions, and damage may result.
iPhone/iPod models usable with this unit
• The unit can be used with the following iPhone/iPod models.
iPhone 3G (version 2.0)
iPhone (version 1.1.4)
iPod touch (version 1.0.4)
iPod classic (version 1.1.1)
iPod nano (3rd generation) (version 1.1)
iPod nano (2nd generation) (version 1.1.3)
iPod with video (version 1.2.3)
iPod nano (1st generation) (version 1.3.1)
This unit USB Connection Terminal
USB memory
(sold separately) Cable (sold
separately)
or
USB memory
(sold separately)
iPhone/iPod
(Optional)
1 /AF
VIEW
Rotary encoder
/ESC /ENT
Preset buttons
(1 through 3)
Preset buttons
(4 through 6) 2 /REPEAT 4
/SHUFFLE 5
6
SOURCE/
/