Sony STR-DA3400ES User Manual
Page 48
48
US
D:\Cannes\STR-DA3400ES_U_R1\3289137121\3289137121\3289137121\01US-
STRDA3400ESUC\030CON.fm
masterpage: Left
STR-DA3400ES
3-289-137-12(1)
3
Press
B/b repeatedly to select
“Yes”, then press
.
4
Press
V/v repeatedly to select
the Auto Calibration type, then
press .
The measurement results are saved.
5
Press
b.
The exit screen appears.
6
Press
to
exit.
Note
The frequency response measurement result is not
utilized in the following cases.
– The multi channel input is selected.
– “2ch Analog Direct” is being used.
– Dolby TrueHD signals with a sampling frequency
of more than 96 kHz are being received.
– PCM signals with a sampling frequency of more
than 96 kHz are being received.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Speaker settings
menu. Save the measurement results first, then try to
change the settings if you want.
Parameter
Explanation
Full Flat
Makes the measurement of
frequency from each
speaker flat.
Engineer
Sets the frequency to one
that matches that of the
Sony listening room
standard.
Front Reference Adjusts the characteristics
of all the speakers to match
the characteristics of the
front speaker.
OFF
Sets the Auto Calibration
EQ to off.