Asus M3N-HD - Manual (Page 145)

ASUS M3N-HD/HDMI M3N-HD/HDMI 5-35
3. Make the proper network configurations.
Each network interface is enabled immediately when you check the box next
to it.
• If you use a network cable connected to a home router (which is then
connected to your DSL/cable modem), enable both LAN1 and LAN2. Express
Gate Lite will automatically use whichever port (LAN1 or LAN2) is connected.
If you plug the network cable into a different port while Express Gate Lite is
running (e.g. move the cable from LAN1 to LAN2), you may need to restart
Express Gate LIte for it to detect the change.
• The most common scenario is for your computer to automatically obtain
network settings (i.e. DHCP). If this is the case, you don’t need to click Setup
for any LAN port. If this is not the case, click Setup to configure the static IP
settings manually.
• If you use wireless, click Setup for the WiFi option. In the WiFi tab of the
Advanced Network Settings box, enter the name of your wireless access
point in the SSID field. If your wireless access point has security enabled,
select the corresponding security algorithm from the drop-down list (e.g.
WEPAUTO) in the Encryption Type field, and enter the password.
Click OK to enable WiFi and establish the wireless connection.
• If you use a network cable connected directly to your DSL/cable modem (no
router in between), click Setup for xDSL/cable dial-up. This method is also
referred to as PPPoE. Choose whether the DSL/cable modem is connected
to your computer’s LAN port. Then enter the username and password for your
dial-up account.
Click OK to enable xDSL/cable dial-up and establish the PPPoE connection.
When PPPoE is enabled, the port it uses will automatically be unchecked and
grayed out.