Sony KDF-E60A20 - Manual (Page 35)

Connecting the TV
33
Co
nnec
ting the
T
V
KDF-E55/60A20
2-593-962-11(3)
VCR and Cable Box Use this hookup if:
❑ Your cable TV company scrambles some channels, but not all of them
(pay channels vs. regular cable channels) and you need to use a cable
box.
With this setup you can:
❑ Use the TV’s remote control to change channels on your cable box
when the signal is scrambled. To program your Sony remote control to
operate your cable box, see “Programming the Remote Control” on
page 44.
❑ Use the TV’s remote control to change channels on your TV when the
signal is not scrambled. Your TV’s tuner provides a better picture
quality than the output of your cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the single (input) jack of the splitter.
2
Use a coaxial cable to connect one of the splitter’s two output jacks to
the TV’s CABLE jack.
3
Use a coaxial cable to connect the splitter’s other output jack to the
cable box’s input jack.
4
Use a coaxial cable to connect the cable box’s output jack to the VCR’s
RF input jack.
5
Use an A/V cable to connect the cable box’s A/V output jacks to the
TV’s A/V input jacks.
6
Use an A/V and S VIDEO cables to connect the VCR’s AUDIO and
S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN input
jacks.
7
Run Auto Program, as described in “Setting Up the TV Channel List”
on page 30.
Before connecting a
cable box, see “Using
CableCARD Device” on
page 25.
✍
To view scrambled channels, tune the TV to the channel the cable box is
set to (usually channel 3 or 4) and then use the cable box to switch
channels.
(Continued)