Sony KDF-E60A20 - Manual (Page 13)

Introducing the Sony TV
11
Intr
oduc
ing
the So
n
y
TV
KDF-E55/60A20
2-593-962-11(3)
Indicators The indicators show the current status of your TV. If there is a change in the
condition or a problem with the TV, the indicators will flash or light up in
the manner described below to let you know that it requires your attention.
Projection Lamp Your TV uses a projection lamp as its light source. As with any lamp, it has
lifespan and needs to be replaced when the Lamp indicator flashes or the
screen becomes darker. The projection lamp is located under the Control
Panel cover as shown in the diagram above. Note the following:
❑ After turning on your TV, it may take a while (1 minute or less) before
the picture appears.
❑ When the projection lamp wears out, the screen goes dark. Replace the
lamp with a new Sony XL-2200 replacement lamp (not supplied).
LAMP TIMER POWER
POWER
Screen
Projection lamp Indicators
Indicator Flashing because...
POWER
(green) flashing The lamp for the light source is preparing to turn on. When
it is ready, it turns on.
POWER
(red) flashing The lamp cover is not securely attached. The red indicator
will continue to flash in intervals of 3 blinks at a time until
the lamp cover is placed correctly. When the lamp cover is
securely attached the TV will turn on with green indicator.
TIMER indicator is
lit. When one of the timer is set, the indicator will remain lit
(will not flash) even when the TV is turned off.
LAMP indicator
flashes. The projection lamp has burned out. Replace it with a new
one (see page 14).
How to replace the lamp,
see page 76.
✍
The light emitted from the lamp is quite bright when your TV is in use. To
avoid eye discomfort or injury, do not look into the light housing when
the power is on.