Sony XAV-72BT - Manual (Page 15)

15
Radio
Listening to the radio
1
Touch “Source List,” then “Tuner.”
From the top menu, touch “AV Source,” then
“Tuner.”
The radio reception display appears, and the
preset list is displayed automatically.
2
Touch “Band.”
The band list appears.
3
Touch the desired band (“FM1,” “FM2,”
“FM3,” “AM1,” or “AM2”).
Touch “Band” again to close the band list.
4
Perform tuning.
To tune automatically
Touch
./> .
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
To tune manually
Touch
m/M repeatedly until the desired
frequency is received.
To skip frequencies continuously, touch and
hold
m/M .
Reception controls
Touch the display if the reception controls are not
displayed.
ATT Source List
Band
Receive
Menu
Preset
List
PTY
List
Top
P1 P2 P3
BTM
Memory
P4 P5 P6
ATT
Band
FM1
Receive
Menu
Preset
List
FM2 FM3 AM2
PTY
List
Top
AM1
Source List
1 “Source List”
Touch to open the source list. (page 13)
2 “ATT”
Touch to attenuate the sound. To cancel,
touch again.
3 “Top”
Touch to open the top menu. (page 13)
4 m/M
Touch to tune manually.
Touch and hold to continuously skip
frequencies.
5 ./>
Touch to tune automatically.
6 “Band”
Touch to open the band list and change
the band.
7 “Receive Menu”
Touch to open the receive menu, which
contains the following items.
• “Mono”: Touch to activate monaural
mode if FM reception is poor. To restore
stereo reception, select “OFF.”
• “Local”: Touch to tune only to stations
with strong signals. To tune normally,
select “OFF.”
8 “Preset List”
Touch to list up stored stations, or store
stations. (page 16)
9 “PTY List”
Touch to open the PTY list. (page 17)
ATT
Band
Receive
Menu
Preset
List
PTY
List
Top Source List
1
4 5 6
2 3
7 8 9