Sony VGN-FS550 - Manual (Page 97)

Connecting the Port Replicator
When using the port replicator, always use the AC adapter to power the port replicator; otherwise, the port
replicator will be without power and will not function properly. Also, take precautions to avoid disconnecting the AC
power supply when moving the computer with the port replicator attached.
Before you connect the port replicator, you may want to install the rechargeable battery, if it is not already installed. The
installed battery automatically charges while the computer and port replicator are powered by the AC adapter.
Connecting a port replicator while the computer is in a power saving mode (Standby or Hibernate) may result in data
loss or a computer malfunction.
To connect a port replicator
1. Close active programs to prevent data loss.
2. Turn off the computer, and disconnect all attached devices.
3. On the bottom of the computer, slide the port replicator cover down until the port replicator connector is
completely visible.
Sliding the Port Replicator Cov er
4. Place the port replicator on a stable surface.
5. Align the sides of the computer with the sidewalls of the port replicator.
Connecting the Com puter and Port Replicator
6. Gently place the computer on top of the port replicator until it clicks into place.
Securing the Port Replicator to the Com puter
Page 97