Removing and installing memory modules – Sony VGN-FS550 User Manual
Page 123
Removing and installing memory modules
Make sure you read the safety information in
before you remove or install a memory module.
When installing a memory module, do not open the module package until you are ready to install it. The package protects
the module from Electrostatic discharge (ESD).
To remove a memory module
1.
Turn off the computer and all attached devices.
2.
Disconnect the power cord, all cables, and remove the battery if it is installed. See
3.
Wait for the computer to cool down.
The interior of the computer becomes extremely hot during operation. Wait at least one hour for the computer to
cool down before you remove the screw.
4.
Turn the computer over and use a screwdriver to loosen and remove the screw on the cover of the memory slot.
To avoid damaging the computer, do not remove or loosen any other screws.
Rem ov ing the Bottom Screw
5.
Remove the memory slot cover carefully.
6.
Touch a metal object to discharge static electricity.
Avoid touching any part of the motherboard or other components inside the computer.
7.
Remove the memory module by pulling out the tabs (see arrows No. 1), and pulling out the module in the
direction of arrow No. 2. See
for more information.
Rem ov ing a Mem ory Module
To install a memory module
1.
Remove the new memory module from its packaging.
2.
Install the memory module by sliding it into the open slot at a 45-degree angle. See
Align the grooves on the memory module with the grooves in the slot.
Installing a New Mem ory Module
Page 123