Sony CMT-MX700Ni - Manual (Page 59)

59 GB
Tr
ou
bl
esh
oot
in
g
, Are the + and – speaker cords short-circuited?
, Are you using only the supplied speakers?
, Is anything blocking the ventilation holes of the
system?
, The specified station may have temporarily stopped
broadcasting.
, Place the speakers as symmetrically as possible.
, Connect only the supplied speakers.
, Move the system away from any sources of noise.
, Connect the system to a different wall outlet.
, Install a noise filter (not supplied) to the power cord.
, Remove any obstacles between the remote and the
remote sensor on the unit, and position the unit away
from fluorescent lights.
, Point the remote at the sensor on the unit.
, Move the remote closer to the system.
, The batteries may be run down. Replace the batteries
with new ones.
, The STANDBY indicator may not turn off
immediately after unplugging the power cord. The
indicator will turn off after about 40 seconds. This is
not a malfunction.
, Wipe the disc clean, and replace it.
, Move the system to a location away from vibration
(for example, to the top of a stable stand).
, Move the speakers away from the system, or place
them on separate stands. At high volume, speaker
vibration may cause the sound to skip.
, Return to Normal Play by pressing PLAY MODE
repeatedly until both “PGM” and “SHUF” disappear.
, The following discs can increase the time it takes to
start playback:
• a disc recorded with a complicated tree structure.
• a disc recorded in multisession mode.
• a disc that has not been finalized (a disc to which
data can be added).
• a disc that has many folders.
, Connect the antenna properly.
, Find a location and an orientation that provide good
reception, and then set up the antenna again.
, Keep the antennas away from the speaker cords and
the power cord to avoid picking up noise.
, Turn off nearby electrical equipment.
, Check all antenna connections, then perform the
DAB Initial Scan procedure (see “Performing a DAB
Initial Scan manually” (page 32)).
, The current DAB/DAB+ service may not be
available. Press +/– to select a different service.
, If you have moved to another area, some services/
frequencies may have changed and you may not be
able to tune into your usual broadcast. Perform the
DAB Initial Scan procedure to re-register the
contents of broadcasts. (Performing this procedure
clears all previously stored presets.)
, Make sure the iPod/iPhone is connected securely.
, Make sure the iPod/iPhone is playing music.
, Adjust the volume.
, Make sure the iPod/iPhone is connected securely.
, Turn down the volume.
, Set the “EQ” setting of the iPod/iPhone to “Off” or
“Flat.”
There is no sound.
Sound comes from only one channel, or the
left and right volumes are not balanced.
There is a severe hum or noise.
The remote does not function.
The STANDBY indicator remains lit after
unplugging the power cord.
CD/MP3 player
The sound skips, or the disc will not play.
Playback does not start from the first track.
Starting playback takes more time than usual.
Tuner
There is a severe hum or noise, or stations
cannot be received (“TUNED” or “ST” flashes
on the display).
The DAB/DAB+ radio station is not received
properly (CMT-MX750Ni only).
iPod/iPhone
There is no sound.
The sound is distorted.