beautypg.com

Maintenance, Storage, Service and adjustments – Agri-Fab 250 LB.TOW BROADCAST SPREADER 45-03642 User Manual

Page 9

background image

9

FERTILIZER
Powder

3 - 5

3' - 4'

Granular

3 - 5

8' - 10'

Pelleted

3 - 5

10' - 12'

Organic

6 - 8

6' - 8'

GRASS SEED
Fine

3 - 4

6' - 7'

Coarse

4 - 5

8' - 9'

ICE MELTER

6 - 8

10' - 12'

TYPE

SPREAD

MATERIAL

FLOW SETTING

WIDTH

APPLICATION CHART

OPERATING SPEED - 3 MPH. (100 ft. in 23 seconds)

IMPORTANT: Application rates shown in the chart are
affected by humidity and by the moisture content of
the material (granular and pellet). Some minor setting
adjustments may be necessary to compensate for this
condition.

CHECK FOR LOOSE FASTENERS
1.

Before each use make a thorough visual check of the

spreader for any bolts and nuts which may have loosened.
Retighten any loose bolts and nuts.

CHECK FOR WORN OR DAMAGED PARTS
2. Check for worn or damaged parts before each use.

Repair or replace parts if necessary.

FIGURE 19

1. Rinse inside of hopper and exterior of spreader and dry

off before storing.

2. Store in a clean, dry area.

CAUTION: DO NOT inflate tires beyond the
maximum recommended pressure printed on
side of tire.

CLEANING
4. Rinse inside of hopper and exterior of spreader and dry

off before storing.

LUBRICATE (See figure 19)
5. Lightly apply automotive grease as needed to the

sprocket and gear.

6. Oil the nylon bushings on the vertical sprocket shaft

and on the axle at least once a year, or more often as
needed.

7. Oil right hand (idler) wheel bearing at least once a year

or more often as needed.

MAINTENANCE

GREASE

OIL

OIL

STORAGE

1. If the axle, slotted gear and sprocket assembly is

disassembled, mark down the positions of the parts as
they are removed. The drive wheel and sprocket positions
in relation to the slotted gear determine which direction
the spreader plate will spin. Be sure to reassemble them
in their original positions. (Refer to figure 4 on page 5.)
Use shim washers (Ref. no. 21 on pages 10 and 11)
as needed for minimum backlash. Add grease to gear
and sprocket.

SERVICE AND ADJUSTMENTS

FIGURE 18

OVERLAP

REFER

TO

CHARTS

CHECK TIRE INFLATION
3. Check if tires are adequately inflated before each use. Do

not inflate beyond maximum recommended pressure.

This manual is related to the following products: