beautypg.com

On off, Adjustable stop (s) (setting "5"), R) nylon wing nut – Agri-Fab 250 LB.TOW BROADCAST SPREADER 45-03642 User Manual

Page 7: Clips

background image

7

25. Position the flow control mounting bracket (figure 14).

a. Push flow control arm to "OFF" position.
b. Slide flow control mounting bracket along tube until

closure plate in bottom of hopper just closes.

c. Snug the 5/16" lock nuts just enough to hold flow

control mounting bracket in place.

d. Set adjustable stop at "5". Pull flow control arm

against stop. Verify that closure plate has opened
about half way.

e. If closure plate does not open half way, adjust

position of flow control mounting bracket until
closure plate will open about half way at "5" and
will still close when arm is locked in "OFF" position.
Tighten the 5/16" lock nuts.

FIGURE 14

FIGURE 12

FLOW
CONTROL
ARM

OFF

ON

1

2

3

4

6

7

8

9

10

5

ADJUSTABLE
STOP (S)
(SETTING "5")

ON

OFF

(R) NYLON
WING NUT

OFF

ON

1

2

3

4

6

7

8

9

10

5

(K) 5/16" FLAT
WASHER

(J) NYLON
WASHER

(S) ADJUSTABLE

STOP

(F) 1/4" x 3/4"

CARRIAGE BOLT

26. Place the screen down into the hopper, sliding the edge

of the screen under one of the clips. Slightly bow the
screen to slide the opposite side of the screen under
the other clip. See figure 15.

FIGURE 15

CLIPS

23. Place the adjustable stop (S) into the "ON" end of the slot

in the top of the flow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt (F), a nylon washer
(J), a 5/16" flat washer (K) and the nylon wing nut (R).
See figure 12.

OFF

ON

1

2

3

4

6

7

8

9

10

5

(X) SPRING

FLOW
CONTROL
ROD

FIGURE 13

24. Slide the adjustable stop to the end of the slot. Move the

flow control arm against the stop. Assemble the spring
(X) to the flow control mounting bracket and then to the
flow control rod. See figure 13.

This manual is related to the following products: