Agri-Fab 250 LB.TOW BROADCAST SPREADER 45-03642 - Manual (Page 5)

5
FIGURE 4
12. Turn the spreader upright on its wheels.
13. Assemble the flow control mounting tube to the hitch
tube using two 5/16" x 1-3/4" hex bolts (A) and 5/16"
nylock hex nuts (H).
DO NOT TIGHTEN YET. See figure
5.
14. Assemble the vinyl cap (T) onto the flow control mounting
tube. See figure 5.
FIGURE 5
9. Assemble a spacer (Q), a 3/4" flat washer (L), a wheel
(air valve facing out) and another 3/4" flat washer (L)
onto the end of the axle that has both the
large and
small holes. See figure 4.
10. Install a 1/8" x 1-1/2" cotter pin (N) into the small hole
in the end of the axle. See figure 4.
11. Open the bail on the drive pin (W) and install it through
the wheel and the large hole in the axle. Close the bail
to lock the pin in place. See figure 4.
FIGURE 7
(H) 5/16" NYLOCK
HEX NUT
(A) 5/16" x 1-3/4"
HEX BOLT
(K) 5/16"
FLAT WASHER
OFF
ON
1 2 3
4
6 7 8 9
10
5
(W) DRIVE PIN
AIR VALVE
(Q) SPACER
(L) 3/4" FLAT
WASHER
(N) 1/8" x 1-1/2"
COTTER PIN
FIGURE 6
(B) 1/4" x 1-3/4"
HEX BOLT
(G) 1/4" NYLOCK
HEX NUT
HITCH BRACE
INNER
FLOW CONTROL
MOUNTING TUBE
HITCH BRACE
INNER
15. Assemble the two inner hitch braces to the flow control
mounting tube using a 1/4" x 1-3/4" hex bolt (B) and a
1/4" nylock hex nut (G).
DO NOT TIGHTEN YET. See
figure 6.
16. Tighten all nuts and bolts assembled up to this point.
Do not collapse the tubes when tightening.
17. Assemble the flow control mounting bracket to the flow
control mounting tube using two 5/16" x 1-3/4" hex bolts
(A), four 5/16" flat washers (K) and two 5/16" nylock hex
nuts (H).
DO NOT TIGHTEN YET. See figure 7.
(A) 5/16" x 1-3/4"
HEX BOLT
(H) 5/16" NYLOCK
HEX NUT
(T) VINYL CAP
FLOW CONTROL
MOUNTING TUBE