beautypg.com

Agri-Fab 250 LB.TOW BROADCAST SPREADER 45-03642 User Manual

Page 6

background image

6

22. Place a 5/16" flat washer (K) onto the other end of the

flow control rod. Insert the end of the rod through the
curved slot in the flow control mounting bracket and
through the hole in the flow control link. Secure with a
5/16" flat washer (K) and a 3/32" x 3/4" cotter pin (M).
See figure 11.

NOTE: You can leave off the second washer if there is not
enough room on the end of the rod.

21. Hook the double bent end of the flow control rod through

the hole in the slide gate bracket located near the bottom
of the hopper. See figure 10.

FIGURE 10

FIGURE 9

20. Assemble the flow control arm to the flow control

mounting bracket using a 1/4" x 1" hex bolt (E), two
nylon washers (J) and a 1/4" nylock hex nut (G).

Tighten

carefully. The flow control arm should be snug but
should pivot with no more than slight resistance. See
figure 9.

18. Assemble the vinyl grip (U) onto the flow control arm.

See figure 8.

19. Insert the flow control arm down through the slot in the

flow control bracket. Assemble the small hole of the flow
control link (V) to the flow control arm using a 1/4" x 1"
hex bolt (E), a nylon washer (J) and a 1/4" nylock hex
nut (G) as shown in figure 8.

Tighten carefully. The

flow control link should be snug but should pivot with
no more than slight resistance.

FIGURE 11

FIGURE 8

(E) 1/4" x 1"
HEX BOLT

(G) 1/4" NYLOCK

HEX NUT

OFF

ON

1

2

3

4

6

7

8

9

10

5

(V) FLOW

CONTROL

LINK

(small hole)

(J) NYLON
WASHER

(U) VINYL GRIP

OFF

ON

1

2

3

4

6

7

8

9

10

5

(E) 1/4" x 1"
HEX BOLT

(G) 1/4" NYLOCK

HEX NUT

(J) NYLON
WASHERS (2)

FLOW
CONTROL
ROD

OFF

ON

1

2

3

4

6

7

8

9

10

5

(K) 5/16"
FLAT
WASHER

(M) 3/32"
COTTER PIN

(K) 5/16"
FLAT
WASHER

This manual is related to the following products: