beautypg.com

Assembly instructions – Agri-Fab 250 LB.TOW BROADCAST SPREADER 45-03642 User Manual

Page 4

background image

4

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches

REMOVAL OF PARTS FROM CARTON

Remove all parts and hardware packages from the carton.
Lay out all parts and hardware and identify using the
illustrations on pages 2 and 3.

FIGURE 1

FIGURE 2

FIGURE 3

CROSSOVER
TUBE

HITCH
TUBE

SHAFT

SUPPORT

PLATE

MIDDLE

LOCK

NUT

MIDDLE BOLT

(C) 1/4" x 2"

HEX BOLT

(B) 1/4" x 1-3/4"

HEX BOLT

(G) 1/4" NYLOCK

HEX NUT

(2) HITCH BRACES

OUTER

HITCH
TUBE

(2) HITCH BRACES

OUTER

STACK HITCH BRACES AS SHOWN

SMALL HOLE

(Q) SPACER

(L) 3/4"
FLAT WASHER

(N) 1/8" x 1-1/2"
COTTER PIN

AIR VALVE

1. Turn the spreader upside down as shown in figure 1.
2. Remove the lock nut from the middle bolt in the crossover

tube and shaft support plate. Leave the bolt in place.
See figure 1.

3. Assemble the hitch tube onto the middle bolt and secure it

with the same lock nut you removed.

DO NOT TIGHTEN

YET. See figure 1.

IMPORTANT: The hitch tube must attach to the side of the
crossover tube opposite the shaft support plate.

ASSEMBLY

4. Stack the hitch braces into two sets of three, making

sure the raised sides of the braces are facing the same
direction. See figure 2.

5. Assemble the six hitch braces (three per side) to the

inside of the hopper frame using a 1/4" x 1-3/4" hex
bolt (B) and 1/4" nylock hex nut (G) on each side.

DO

NOT TIGHTEN YET. The hitch braces should be able
to move freely. See figure 2.

7. Assemble a spacer (Q), a 3/4" flat washer (L), a wheel

(air valve facing out) and another 3/4" flat washer (L)
onto the end of the axle that has only the

small hole.

See figure 3.

8. Install a 1/8" x 1-1/2" cotter pin (N) into the hole in the

axle. See figure 3.

6. Assemble the two

outer hitch braces on each side to

the hitch tube using a 1/4" x 2" hex bolt (C) and a 1/4"
nylock hex nut (G).

DO NOT TIGHTEN YET. Do not

assemble the two inner hitch braces at this time. See
figure 2.

This manual is related to the following products: