Sony MZ-R37 - Manual (Page 30)

30
Messages
If the following error messages flash in the display window, check the chart below.
Error message
BLANK
ERROR
FULL
EDIT
BUSY
HiDCin
HOLD
LoBATT
MEMORY
Meaning/Remedy
• An MD with no recording on it is inserted.
b Insert a recorded MD.
• The disc is damaged or does not contain proper recording or
editing data.
b Reinsert the disc. If this fails, rerecord.
• There is no more space to record on the disc (less than 12 seconds
available).
b Replace the disc.
• You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names during playback or stop.
• You tried to enter a total of more than 500 letters for track or disc
names during a single recording.
b Enter the characters within the limit.
• The MD player is recording information (track start and end
position) from the memory to the disk.
b Wait until this process is completed. Do not expose the player
to physical shock, nor disrupt power supply.
• You tried to operate the recorder while it was accessing the
recorded data.
b Wait until the message goes out (in rare cases, it may take 2–3
minutes).
• Voltage of the power supply is too high (The supplied AC power
adaptor is not used).
b Use the supplied AC power adaptor.
• The recorder is locked.
b Slide HOLD against the arrow to unlock the recorder (page 17).
• Batteries are weak.
b Charge the rechargeable batteries or replace the dry batteries
(pages 23, 24).
• You tried to record when there is no indication in the display, with
the recorder placed where it receives continuous vibration.
b Put the recorder on a stable place, and start recording again.