American Dryer Corp. AD-115ES - Manual (Page 30)

26
F. ELECTRICAL INFORMATION
1. Electrical Requirements
It is your responsibility to have ALL electrical connections made by a properly licensed and competent
electrician to assure that the electrical installation is adequate and conforms with local and state regulations
or codes. In the absence of such codes, ALL electrical connections, material, and workmanship must conform
to the applicable requirements of the National Electrical Code ANSI/NFPA NO.70-LATEST EDITION or in
Canada, the installation must conform to applicable Canadian Standards: Canadian Electrical Codes Parts
1 & 2 CSA C22.1-1990 or LATEST EDITION (for Electrical Connections).
IMPORTANT: Failure to comply with these codes or ordinances, and the requirements stipulated in
this manual can result in personal injury or component failure.
NOTE: Component failure due to improper installation will VOID THE WARRANTY.
Each dryer should be connected to an independently protected branch circuit. The dryer must be connected
with copper wire ONLY. DO NOT use aluminum wire which could cause a fire hazard. The copper
conductor wire and cable must be of proper ampacity and insulation in accordance with electric codes for
making ALL service connections.
NOTE: The use of aluminum wire will VOID THE WARRANTY.