Sony XBA-BT75 - Manual (Page 11)

11
GB
XBA-BT75 [CE7 (GB, FR, DE, ES, NL)] 4-411-333-41(1)
Pairing
What is pairing?
Bluetooth devices need to be “paired”
with each other beforehand.
Once Bluetooth devices are paired, there
is no need for pairing again, except in the
following cases:
 Pairing information is deleted after
repair, etc.
 When you attempt to pair with 9 or
more devices.
This unit can be paired with up to 8
devices; if a new device is paired after 8
devices have been paired, the device
whose latest connection time is the
oldest among the 8 paired devices is
replaced by the new one.
 When recognition of the unit by the
device to be connected is deleted.
 This unit is initialised (page 24). All
pairing information is deleted.
Pairing procedures
Before pairing, charge the headset (page
8, 9).
1
Place the Bluetooth device within
1 m of this unit.
While this unit is turned off, press
and hold the button until the
indicator flashes blue and red
alternately.
The unit enters pairing mode. (It
takes about 7 seconds normally to
enter pairing mode. When pairing for
the first time, or the unit is initialised,
etc., pairing takes about 2 seconds.)
(Multi function) button
Note
If pairing is not established within about
5 minutes, pairing mode will be
cancelled and this unit will turn off. In
this case, start over from step 1.
Perform the pairing procedure on
the Bluetooth device to detect this
unit.
The list of detected devices appears on
the display of the Bluetooth device.
This unit is displayed as “XBA-BT75.”
If “XBA-BT75” is not displayed,
repeat from step 1.
Note
For details, refer to the operating
instructions supplied with the Bluetooth
device.
Continued