Samsung SC-D23-XAP - Manual (Page 28)

ENGLISH
24 24
Preparation
Using the Lithium Ion Battery Pack
✤ The amount of continuous recording time available depends on :
-
The type and capacity of the battery pack you are using.
- How often the Zoom function is used.
It is recommended that you have several batteries available.
Charging the Lithium Ion Battery Pack
1. Attach the battery pack to the camcorder.
2. Connect the AC Power adapter to an AC cord and connect
the AC cord to a wall socket.
3. Connect the DC cable to the DC jack socket on the camcorder.
4. Turn the Camera power switch to off, and the charging indicator
will start to flash, showing that the battery is charging.
5. When the battery is fully charged, disconnect the
battery pack and the AC Power adapter from the camcorder.
■ Even with the power switched off, the battery pack will still discharge
if it is left connected to the camcorder.
Notes
■ The battery pack may be charged a little at the time of purchase.
■ To prevent reduction in the life and capacity of the battery pack, always remove it from the camcorder after it is fully
charged.
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90 ~ 100%
On for a second and Error - Reset the battery pack and
off for a second the DC cable
MUL TI
5
00616B SCD23-SEA(01~27) 5/12/03 9:46 AM Page 24