AEG 7200 - Manual (Page 42)

Setting up and connection instructions
42
3 The special button A and the plug caps B (2 ea.) and C (1 ea.) are
supplied with the unit.
3. Remove the screw D, including
the compression spring with the
special button A.
4. Close off the hole with the plug
cap C.
Attention! Push in the plug cap
so firmly that it engages in the
rear panel (this protects the inside
of the unit against splash water).
5. Unscrew the two screws E using
the special button A.
6. Unscrew the four screws F using
the special button A.
7. Remove the transport rail G.
8. Screw the four screws F back in.
9. Close off the two large holes with
the plug caps B.
Attention! Push in the plug caps
so firmly that they engage in the
rear panel (this protects the inside
of the unit against splash water).