AEG 7200 - Manual (Page 24)

Instructions for use
24
End of wash cycle/Taking out washing
When the programme is completed, the END (EINDE, FIN) light on the
progress indicator comes on.
If RINSE HOLD (GEEN CENTR., SANS ESSOR.) was selected, the indicator
beside the START/PAUSE (START/PAUZE, MARCHE/PAUSE) button
flashes.
0 1. After a Rinse Hold, the water must be pumped out first:
– Press either the START/PAUSE (START/PAUZE, MARCHE/PAUSE)
button (the water is pumped out, and the spin cycle starts (depending
on the programme; pressing the START/PAUSE (START/PAUZE,
MARCHE/PAUSE) button again allows you to change the spin speed,
even while spinning is in progress),
or
– turn the programme selector to OFF (UIT, ARRET), then to PUMP OUT
(POMPEN, VIDANGE) and press the START/PAUSE (START/PAUZE,
MARCHE/PAUSE) button (the water is pumped out without spin-
ning),
or
– turn the programme selector to OFF (UIT, ARRET), then to SPIN (CEN-
TRIFUG., ESSORAGE) or GENTLE SPIN (KORT CENTRIFUG., ESSOR. DELI-
CAT), then press the START/PAUSE (START/PAUZE, MARCHE/PAUSE)
button (the water is pumped out and the Spin or Gentle Spin cycle
starts).
When this programme stage is ended, the END (EINDE, FIN) indicator
light comes on.
2. Open the door.
The door can be opened when the END (EINDE, FIN) light comes on.
3. Take out the washing.
4. Turn the programme selector to OFF (UIT, ARRET).
5. Close the water supply tap.
6. When washing is complete, pull the detergent dispenser drawer out
to let it dry. Leave the door open for a while, to air the inside of the
machine.
Attention! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.