Appendix e: adjusting ribbon tension – AMT Datasouth FASTMARK 4600 User Manual
Page 89
89
Appendix E: Adjusting Ribbon Tension
The ribbon shaft has its user-friendly feature to allow users to adjust the tension
of ribbon shaft by rotating the knob. User can reset to factory default tension by
adjusting the ribbon shaft while the black line was aligned to the marked arrows.
Appendix F: Switching Ribbon Wound Ink-side out or Ink-side in
The printer is produced to suit flexible applications, no matter with ribbon wound
ink-side in (manufacturing default), or with ribbon wound ink-side out. The steps
to switch are listed as follows:
1. Pull and move the SHAFT RIBBON ADJ into the Inside:
This manual is related to the following products: