Karcher CV 60-2 RS User Manual
Page 18
-
7
Faults
Fault
Remedy
By whom
Appliance cannot be started
Insert the battery plug on the device.
Operator
Swivel the top of the appliance down and close the lock.
Operator
Release emergency-stop button by turning.
Operator
Check battery cable for correct sitting.
Operator
Check battery cable for corrosion; clean, if required.
Operator
Battery capacity exhausted; recharge battery.
Operator
Remove the power plug from the charger and hook the holder into the appliance.
Operator
Device does not drive or drives
only slowly
Release accelerator pedal, turn the key switch to "0", turn the key switch to "1", press
the accelerator pedal.
Operator
Reset the fuse.
Operator
Set the unlock lever to "drive".
Operator
Charge battery.
Operator
Motor or control overheated; switch off the appliance and let it cool down for 5 minutes. Operator
Remove obstacles from the wheels or push the appliance away from the obstacle.
Operator
Device does not brake
Park brake deactivated; pull the unlock lever down to activate.
Operator
No or inadequate suction power Reset fuse of suction turbine.
Operator
Clean the seals between the dirt container and the top of the appliance and check for
leaks, replace if required.
Operator
Swivel the top of the appliance down and close the lock.
Operator
Carefully insert the suction pipe into the holder.
Operator
Filter bag full; replace filter bag.
Operator
Charge battery.
Operator
Check suction hose for blockages; clean if required.
Operator
Check the suction hose for tightness; replace if required.
Operator
The battery indicator blinks
Charge battery.
Operator
See "Faults with display".
Operator
Brushes do not turn or turn too
slowly
Reset fuse of brush drive.
Check side brush fuse (F4), replace if required.
Operator
Check the brush for blockage by foreign objects; remove the foreign objects.
Operator
The status indicator of the filter bag illuminates red: Replace the filter bag, empty the
coarse dirt pan.
Operator
Charge battery.
Operator
The cleaning head is not low-
ered.
Reset the fuse for the lift unit of the brush/suction head.
Operator
18
EN