Alto-Shaam AR-7VH - Manual (Page 27)

ቯ
Lamp Assembly
LP-34185
ተ
Radiant Heater
208V - EL-33974
240V - EL-33973
To Replace Bulbs:
A Remove four screws holding glass light cover
(CV-26607) and gasket (GS-26609)in place, taking
care to not let the glass cover (GL-26608) fall into
the oven.
B Pull bulb out
C Push replacement bulb (LP-34213) in place
D Re-install glass cover and gasket, securing with four
screws removed in step one.
I N T E R I O R S E R V I C E V I E W
B U L B R E P L A C E M E N T I N S T R U C T I O N S
A
B & C
D
C A U T I O N
The performance of this unit has been
optimized using the factory provided
bulbs. These bulbs should be
replaced with an exact replacement or
with a factory recommended
replacement. These bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with NSF
standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb filament.
C A U T I O N
DO NOT HANDLE NEW BULB WITH
BARE HANDS. WHITE COTTON
GLOVES SHOULD BE WORN WHEN
REPLACING BULBS.
A R - 7 E R o t i s s e r i e w i t h A R - 7 V H Ve n t l e s s H o o d O p e r a t i o n & C a r e M a n u a l • 2 6
S E R V I C E