Alto-Shaam AR-7VH - Manual (Page 16)

O P E R AT I N G I N S T R U C T I O N S
STANDARD SPITS
Each of the seven rotisserie spits includes two
welded prongs on the square end and one
welded, ridged prong on the tapered end. Insert
the two-prong, square end into the two holes
indicated on the disk assembly drive wheel in the
drawing. Insert the tapered, ridged-prong end
into the top hole indicated on the opposite side
and maneuver until the ridge catches in the hole.
OPTIONAL SPITS/BASKETS
When optional spits are used, insert the spits
in the drive wheel as indicated in the illustration.
When inserting the basket, put the smooth pin
(A)
end in first. When removing the basket, the
machined pin
(B)
comes out first.
IMPORTANT NOTE:
When using a partial quantity of standard or
optional spits, space the spits evenly as possible
around the drive wheel to maintain balance and
even rotation.
S P E C I A L AT T E N T I O N :
A combination of standard, piercing, and
basket spits can be used at the same time but N O T
in every spit insertion position. The use of a spit
in every position will inter fere with the free
rotation of the baskets. Using a combination of
spits can only be accomplished at significantly
reduced rotisserie capacity.
B
A
P R O D U C T L O A D I N G
A R - 7 E R o t i s s e r i e w i t h A R - 7 V H Ve n t l e s s H o o d O p e r a t i o n & C a r e M a n u a l • 1 5
O P E R AT I N G I N S T R U C T I O N S