elektraLite Cool White Dazer - Manual (Page 5)

6. Menus in the fixture.
Root Menu Sub Menu 1 Sub Menu 2
STAT (STATIC LOOK) W(HITE) 0-255
S(STROBE) 0-255
RUN DMX
SLAV(E)
DMX ASSIGN DMX CHANNEL 1-512
PERS (PERSONALITY) WD
WS
WS Id
ID ID 01 THROUGH 255 1-255
SET REST (RESET)
DV
DIM
KEY OFF
ON
7. Static Look.
The Elektralite CW Dazer can be set to a single static look quickly.
Use the Menu button to get to STAT.
Press Enter.
The next screen will read W.000. This is addressing the White leds.
Use the ↑ or ↓ to increase or decrease the output of the leds.
Numbers are expressed in DMX values so 0 is no output and 255 is highest output.
Press Enter to save the value.
The screen will automatically advance to the strobe. S.000 means the strobe is off
Use the ↑ or↓ to increase or decrease the speed of the strobing or leave at S.000 if you want no strobe.
S.001 is the slowest and S.020 is the fastest strobing.
Press Enter to save the value. It will automatically bring you back to the output screen again.
Press the Menu button to exit out of STAT and back to the Root directory.
8. Run Mode.
Run allows the fixture to operate in either DMX or Slave operation.
Using the Menu button in the root menu go to RUN.
Press Enter to get to DMX mode. Press Enter again to save the RUN mode as DMX.
A "ok" will appear and then the display will return to display RUN.
If the fixture is to be run in Slave mode, then when DMX mode appears on the screen instead of
pressing enter use the ↑ or ↓ to get to SLAV. Then press enter to save the SLAV mode setting.