A.J. Antunes & Co VCT-2000 9210410 - Manual (Page 13)

13
VERTICAL CONTACT TOASTER
P/N 1010840 Rev. M 07/14
Replacing Belt Wraps (Every 3–6 months)
NOTE: Depending on toaster usage and how well
they are cleaned daily, the black Belt Wraps should
last 3 to 6 months. Additional Belt Wraps may be
purchased from your Authorized Service Agency.
1. Turn the Rocker Switch off, unplug the power
cord, and allow the unit to cool.
2. Remove the Bun Feeder and Heat Shield and set
the Compression Control Knobs to 6 and 6.
3. Open both Conveyor Covers and pull the Belt
Wrap Pin out of the “zipper” (Figure 11).
4. Remove and discard the old Belt Wrap(s).
5. Clean both Conveyor Belt Chains just as you
would clean the Belt Wraps during daily cleaning
(Figure 11).
6. Install the new Belt Wrap(s) around the Conveyor
Belt Chains inside the yellow rods with the “zip-
per” flap exposed and hanging down (Figures 12
& 13).
7. Close the Conveyor Cover(s), set the
Compression Control Knobs back to their normal
settings and reinstall the Heat Shield and Bun
Feeder.
CAU TIO N
INCORRECT CORRECT
Figure 12. Installing Belt Wrap
Figure 13. Aligning Belt Teeth
Belt Wrap
Pin
Belt Rotation Upper Support Rod
Lower
Support Rod
CAUTION
Align the ends of the Belt Wrap properly (Figure
13) or the Belt Wrap may be damaged. Position
the Belt Wrap between the upper and lower yellow
support rods or damage to the unit may occur.
Figure 11. Removing Belt Wrap
Conveyor
Safety
Interlock
Switch
Conveyor
Cover Assy.
Belt Wrap
Pin
Replacing the Black and Silver Release
Sheet (Every 4–6 weeks)
NOTE: Depending on toaster usage and on how
well it is cleaned daily, the black and silver Release
Sheet should last 45 to 60 days.
1. Remove and discard the Release Sheet.
2. Lay a new Release Sheet on a clean, dry surface
and fold it in half lengthwise and gently crease it
at the fold using only your fingers.
3. Install the Release Sheet.
Fold over so
ends meet. Press Lightly
with finger to
form crease.
Conveyor Belt
Chains
MAINTENANCE (continued)