Nikon D3000 - Manual (Page 5)

iii
A
Observe proper precautions when handling the quick charger
• Keep dry.
Failure to observe this precaution could
result in fire or electric shock.
• Dust on or near the metal parts of the plug should be
removed with a dry cloth. Continued use could result
in fire.
• Do not handle the power cable or go near the charger
during thunderstorms. Failure to observe this
precaution could result in electric shock.
• Do not damage, modify, or forcibly tug or bend the
power cable. Do not place it under heavy objects or
expose it to heat or flame. Should the insulation be
damaged and the wires become exposed, take the
power cable to a Nikon-authorized service
representative for inspection.
Failure to observe this
precaution could result in fire or electric shock.
• Do not handle the plug or charger with wet hands.
Failure to observe this precaution could result in
electric shock.
• Do not use with travel converters or adapters designed
to convert from one voltage to another or with DC-to-
AC inverters. Failure to observe this precaution could
damage the product or cause overheating or fire.
• No part of the manuals included with this product may be
reproduced, transmitted, transcribed, stored in a retrieval
system, or translated into any language in any form, by
any means, without Nikon’s prior written permission.
• Nikon reserves the right to change the specifications of
the hardware and software described in these manuals at
any time and without prior notice.
• Nikon will not be held liable for any damages resulting
from the use of this product.
• While every effort has been made to ensure that the
information in these manuals is accurate and complete,
we would appreciate it were you to bring any errors or
omissions to the attention of the Nikon representative in
your area (address provided separately).
Notices for Customers in the U.S.A.
Federal Communications Commission (FCC) Radio Frequency Interference Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules.
These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications.
However,
there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television
technician for help.
CAUTIONS
Modifications
The FCC requires the user be notified that any changes or
modifications made to this device that are not expressly
approved by Nikon Corporation may void the user’s
authority to operate the equipment.
Interface Cables
Use the interface cables sold or provided by Nikon for your
equipment.
Using other interface cables may exceed the
limits of Class B Part 15 of the FCC rules.
Notice for Customers in the State of California
WARNING
: Handling the cord on this product may expose you
to lead, a chemical known to the State of California to cause
birth defects or other reproductive harm.
Wash hands after
handling.
Nikon Inc., 1300 Walt Whitman Road, Melville, New York
11747-3064, U.S.A.
Tel.: 631-547-4200
Notices
The Battery Charger
IMPORTANT SAFETY INSTRUCTIONS—SAVE THESE INSTRUCTIONS
DANGER—TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, CAREFULLY
FOLLOW THESE INSTRUCTIONS
For connection to a supply not in the U.S.A., use an attachment plug adapter of the proper configuration for the power
outlet if needed. This power unit is intended to be correctly oriented in a vertical or floor mount position.
D3000