Electronically controlled cameras, Shooting – Nikon S3300 User Manual
Page 189
Troubleshooting
F
9
Te
chni
cal
Note
s and
In
de
x
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and reinsert the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Shooting
The camera becomes hot.
The camera may become hot when used for an
extended period of time to shoot movies or
send images using an Eye-Fi card, or when
used in a hot environment; this is not a
malfunction.
–
Problem
Cause/Solution
A
No image captured when
shutter-release button is
pressed.
• When the camera is in playback mode, press
the A button, shutter-release button, or
b
(
e movie-record) button.
• When menus are displayed, press the d
button.
• Battery is exhausted.
• When flash lamp flashes, flash is charging.
The camera cannot focus.
• The subject is too close to the camera. Try
shooting using macro mode, or Scene auto
selector or Close-up scene mode.
• The intended subject is one with which
autofocus does not perform well.
• Select Auto for AF assist in the set up
menu.
• Turn the camera off and then on again.
Images are blurred.
• Use flash.
• Increase the ISO sensitivity value.
• Enable vibration reduction or motion
detection.
• Use BSS.
• Use a tripod to stabilize the camera when
shooting (using the self-timer at the same
time is more effective).
Problem
Cause/Solution
A