American Dryer Corp. Phase 7 / OPL ensor Activated Fire Extinguishing System D120 - Manual (Page 18)

18 JLA Limited 113375 - 6
!
!
!
!
!
!
Air Connection
Air connection to this system is a 1/4” quick connection as
per the illustration below.
Shutdown Instructions ______________
If the dryer is to be shut down (taken out of service) for a
period of time, the following must be performed:
Discontinue power to the dryer either at the external
disconnect switch or the circuit breaker.
Discontinue the heat supply:
GAS MODELS … discontinue the gas supply.
SHUT OFF external gas supply shutoff valve.
STEAM MODELS … discontinue the steam supply.
SHUT OFF external (location furnished) shutoff valve.
Service/Parts Information ___________
Service
Service must be performed by a qualified trained technician,
service agency, or gas supplier. If service is required, contact
the distributor from whom the JLA equipment was purchased.
If the distributor cannot be contacted or is unknown, contact
the JLA Service Department for a distributor in your area.
Note
When contacting the JLA Service Department, be
sure to give them the correct model number and
serial number so that your inquiry is handled in an
expeditious manner.
Parts
Replacement parts should be purchased from the distributor
from whom the JLA equipment was purchased. If the
distributor cannot be contacted or is unknown, contact the
JLA Parts Department for a distributor in your area. Parts
may also be purchased directly from the factory by calling
the JLA Parts Department at 01422 822282 or you may FAX
in your order at 01422 824390.
Note
When ordering replacement parts from the
distributor or JLA be sure to give them the correct
model number and serial number so that your parts order
can be processed in an expeditious manner.
Warranty Information ________________
Returning Warranty Cards
Before any dryer leaves the factory test area, a warranty
card is placed on the back side of the main door glass. These
warranty cards are intended to serve the customer where
we record the individual installation date and warranty
information to better serve you, should you file a warranty
claim.
If a warranty card did not come with your dryer, contact the
JLA Warranty Department.
Important
A separate warranty card must be completed and
returned for each individual dryer.
Note
Be sure to include the installation date when
returning the warranty card(s).
Warranty
For a copy of the JLA commercial warranty covering your
particular dryer(s), contact the distributor from whom you
purchased the equipment and request a dryer warranty form.
If the distributor cannot be contacted or is unknown, warranty
information can be obtained from JLA by contacting the JLA
Warranty Department.
Note
Whenever contacting the JLA factory for warranty
information, be sure to have the dryer’s model
number and serial number available so that your inquiry
can be handled in an expeditious manner.
Routine Maintenance ________________
A program and/or schedule should be established for
periodic inspection, cleaning, and removal of lint from various
areas of the dryer, as well as throughout the ductwork
system. The frequency of cleaning can best be determined
from experience at each location. Maximum operating
efficiency is dependent upon proper air circulation. The
accumulation of lint can restrict this airflow. If the guidelines
in this section are met, a JLA dryer will provide many years
of efficient, trouble free, and most importantly, safe operation.
Warning
Lint from most fabrics is highly combustible. The
accumulation of lint can create a potential fire
hazard.
Keep dryer area clear and free from combustible
materials, gasoline, and other flammable vapors and
liquids.
Note
Remove power from the dryer before performing
any maintenance in the dryer.
Suggested time intervals shown are for average usage
which is considered six to eight operational (running)
hours per day.
!