Nikon 4200 User Manual
Page 23
13
Fi
rst Ste
p
s
The
Button
The camera can also be turned on by pressing the
button for about two seconds.
Your most recent picture will be displayed in the monitor (
The Power-On Lamp
The power-on lamp indicates the following:
Auto Power Off (Standby Mode)
If no operations are performed for one minute (default setting), the monitor will turn
off automatically and the camera will enter standby mode to reduce the drain on the
battery. While the camera is in standby mode, the power-on lamp will blink. If no op-
erations are performed for three minutes after the camera enters standby mode, the
power will turn off automatically and the power-on lamp will go out. The camera will
be reactivated from standby mode when you:
• Press the power switch
• Press the shutter-release button halfway
• Press the
button to view the last picture taken
• Press the MENU button to display the menu for the current mode
• Rotate the mode dial to select a new mode
The length of time before the camera enters standby mode can be changed using the
Auto off option in the setup menu (
119). However, when a menu or the setup
menu is displayed, the monitor will turn off after three minutes, and when pictures are
being shown in a non-stop slide show (
97) or when the camera is powered by an
AC adapter kit, the monitor will turn off after thirty minutes.
When connecting the camera to a computer or printer with a USB cable, Auto power
off function does not work.
When the power-on lamp is
The camera is
On
On
Blinking
In standby mode
Off
Off