PerTronix Dougs Headers D3360 - Manual (Page 3)

Page 3 of 3
Part # 0110-003016 rev 1 8-17-2011 DSL
IMPORTANT CHECK LIST
Be sure that all brake lines and fuel lines are clear of headers and/or connector pipes.
All spark plug wires, battery cables, or other electrical components should be clear of headers
and/or connector pipes.
If dipstick tube was removed, make sure it is installed properly and that the dipstick has been
replaced.
Double-check the tightness of all bolts including brackets and accessories.
START THE ENGINE
Start the engine and allow it to warm up to operating temperature. Check for any unusual noises or
exhaust leaks. If every thing is OK, stop the engine and tighten all bolts while the engine is still warm.
NOTE: Check the bolts periodically to make sure they have not loosened. Re-tighten after the first 500
miles and then again at 1000 miles.
PARTS LIST
Qty. Description
1 Right side header
1 Left side header
1 Right side connector pipe
1 Left side connector pipe
2 Header flange gasket
2 2 1/2
” donut gasket
1 2 1/2 ” band clamp
1 Decal:
DOUG’S HEADERS
1 Sticker (C.A.R.B., E.O., D-57-19)
1 Hardware kit:
16 3/8”-16 x 1 ¼” header bolts
6
3/8”-16 x 2 ¼” hex bolts
6 3/8”-16 hex nuts
22
3/8” lock-washers