PerTronix Ignitor 1143N6 - Manual

6-Volt Negative Ground Installation Instructions
Page 1 of 4
909-599-5955 www.pertronix.com
CAUTION!!! Before installing, please read the following important information....
Page 1 of 4
909-599-5955 www.pertronix.com
1. The Ignitor is designed for 6-Volt negative ground systems.
2. Leaving the ignition “ON” with the engine “OFF” for an extended period could result in permanent damage to
the Ignitor.
3. See Chart on back page for coil recommendations.
4. Four & Six cylinder engines require a minimum of 1.5 ohms of primary resistance. Do not remove resistors if
the coil primary resistance is less than 1.5 ohms.
5. If your Ignition coil has the recommended primary resistance, remove or bypass all external resistors.
Page 1 of 4
For Part Number: 1142N6 & 1143N6
DISASSEMBLY
1. PRIOR TO INSTALLATION TURN IGNITION SWITCH OFF OR DISCONNECT THE BATTERY
2. Check distributor rotation before disassembly. 1142 Ignitor kits are designed for Clockwise rotating
distributors and 1143 kits for Counter Clockwise rotating distributors.
3. Remove the distributor cap, and rotor. Do not disconnect spark plug wires. Examine cap and rotor for wear
or damage. Replace as needed.
4. Disconnect the point wire from the negative (-) terminal of the coil.
5. Remove the point wire, point, and condenser from the distributor. The Ignitor does not require any
modification to the distributor. Therefore the point, condenser and hardware can be used as backup.
6. Clean all dirt and excess oil from the breaker plate and point cam.
IGNITOR INSTALLATION
1. Position the Ignitor over point pivot pin and
eccentric adjustment screw, rotate eccentric screw as needed
to line up screw hole to breaker plate screw hole. Confirm that the Ignitor plate is flat and fits without
modifications. Fasten the plate into place using the original point screw.
2. Insert wires through the wire exit hole in distributor housing. Pull the rubber grommet into place. Make sure
wires do not interfere with any moving parts.
3. Install magnet sleeve over the distributor shaft, onto point cam. Rotate the sleeve until a slight locating
position is felt before applying pressure. Press down firmly insuring sleeve is fully seated.
4. Module and magnet sleeve air gap is not adjustable.
5. Reinstall the rotor, and the distributor cap. Make sure all spark plug wires are securely attached.
6. See Wiring Instructions.