PerTronix Ignitor LU-144P12 - Manual

12-Volt Positive Ground Installation Instructions
Page 1 of 4
909-599-5955 www.pertronix.com
CAUTION!!! Before installing, please read the following important information....
Page 1 of 4
909-599-5955 www.pertronix.com
1. The Ignitor is designed for 12-Volt positive ground systems.
2. Leaving the ignition “ON” with the engine “OFF” for an extended period could result in permanent damage to
the Ignitor.
3. See Chart on back page for coil recommendations.
4. Four & Six cylinder engines require a minimum of 3.0 ohms of primary resistance. Do not remove resistors if
the coil primary resistance is less than 3.0 ohms.
5. If your Ignition coil has the recommended primary resistance, remove or bypass all external resistors.
Page 1 of 4
For Part Number: LU-143P12 & LU-144P12
Figure 1 (LU-144P12)
Figure 2 (LU-143P12)
DISASSEMBLY
1. PRIOR TO INSTALLATION TURN IGNITION SWITCH OFF OR DISCONNECT THE BATTERY
2. Remove the distributor cap, and rotor. Do not disconnect spark plug wires. Examine cap and rotor for wear
or damage. Replace as needed.
3. Disconnect the point wire from the negative (-) terminal of the coil.
4. Remove the point wire, point, and condenser from the distributor. The Ignitor does not require any
modification to the distributor. Therefore the point, condenser and hardware can be used as backup.
5. Clean all dirt and excess oil from the breaker plate and point cam.
IGNITOR INSTALLATION
1. See figure 1 & 2 to determine if you are installing the correct kit.
2. Install Ignitor over point guide pin, line up point screw hole and secure with screw provided.
3. Vacuum advance/Retard distributors only: If the distributor ground wire was removed during the installation
process be sure it is re-attached securely. NOTE: If the ground wire is missing, one needs to be
installed and attached from the point breaker plate to the distributor housing.
4. Insert wires through the wire exit hole in distributor housing. Pull the rubber grommet into place. Make sure
wires do not interfere with any moving parts.
5. Install magnet sleeve over the distributor shaft, onto point cam. Rotate the sleeve until a slight locating
position is felt before applying pressure. Press down firmly insuring sleeve is fully seated.
6. Module and magnet sleeve air gap is not adjustable.
7. Reinstall the rotor, and the distributor cap. Make sure all spark plug wires are securely attached.
8. See Wiring Instructions.
Note: Ignitor LU-143P12 fits 45D4,
44D4 and 43D4 LUCAS distributors
with LUCAS red points.
Note: Ignitor LU-144P12 fits 45D4,
44D4 and 43D4 LUCAS distributors
with LUCAS blue points.